1. Insert a bur into the handpiece.

2. Use the back cap wrench to unscrew the back cap.

3. Push on the bur to force the turbine out from the back of the head.

5. Follow instructions that came with the turbine to properly install. Visit: www.ultimadentalsystems.com

6. Ensure that the back of the turbine sits flush with the back of the head of the handpiece. If not, remove the turbine and repeat installation.

4. Clean the inside of the handpiece head. Use Handpiece cleaner and a cotton swab.

7. Finger-tighten the back cap to ensure thread alignment.

8. Securely tighten with back cap wrench.

Caution
The threads in the head and back cap are very fine. Screw on the back cap with fingers then tighten with wrench. Cross threading the back cap will invalidate warranty and cause the handpiece to be defective.

Note: Please refer to the pamphlet included with the handpiece for more information.